home *** CD-ROM | disk | FTP | other *** search
- ------------------------ 3 ball Juggler ---------------------
- Version 1.13
-
- Make a backup copy of "3 ball Juggler" before starting. If
- you have a two floppy drive system, place the disk with "3 ball
- Juggler" and all its files on it into drive a. Place a new
- formatted disk into drive b and type
-
- copy a:*.* b:
-
- All commands are ended by pressing the <Enter> key. If drive a
- and b are not the same on your system and the "3 ball Juggler"
- disk only fits in b drive then just reverse the above
- instructions. Put the original disk in a safe place and use the
- copy to run "3 ball Juggler".
-
- To copy "3 ball Juggler" to a hard drive make a directory
- with
-
- md jug
-
- or any other directory name. Change to that directory with
-
- cd jug
-
- and copy all of the files on the original disk to the hard disk
- with the command
-
- copy a:*.*
-
- (or "copy b:*.*" if the disk containing 3 ball Juggler" is in
- drive b).
-
- To start "3 Ball Juggler" go to the drive and directory
- containing the program and type "j <Enter>". You may optionally
- start the program in the silent mode with "j -s". There are four
- different jugglers available in the program. These can be
- selected in the Setup menu or from the command line with "j -#"
- where "#" is 1, 2, ... depending on the juggler desired. Both
- switches can be combined. For example "j -s2" starts "3 ball
- Juggler" in the silent mode with juggler number 2.
-
- Once inside the game at the main menu, press h or F1 for
- more instructions. Each menu has its own help message. Be sure to
- read them all.
-
- In the lesson and trick menus, it is possible to turn the
- tracing on or off by pressing F3. The tracing is the dots left
- behind by the balls to show the path the balls take. When the
- tracing is turned off, the dots on the screen stay behind until
- the next screen but no new dots are painted. This allows you to
- trace a portion of a trick or lesson.
-
- As an example, go into the 3-in-1-hand Trick demo and turn
- off the tracing. If there are still some dots on the screen,
- restart the demo by pressing R. After the trick has started,
- press F3 and watch the tracing for a couple seconds. Then press
- F3 again and see that no new dots are painted (dot colors do not
- change when a ball goes over them). You can use the F3 key to
- capture the paths in any portion of a trick.
-
- I hope you like "3 ball Juggler" and will register it. See
- the registration section of the main menu for a special offer on
- "5 ball Juggler".
-